Bucket bits wanted & services needed

**Crock** · 24th April 2011, 12:38

Originally Posted by Moooools

You will probably have to make your own. You can buy a cable kit and some different ends (if they are not included) and solder yourself one up if you go to the right sort of motorcycle dealer - probably a more dirt oriented place.

There may be something sock thats works though.

thanks but now all sorted thanks to a bit from Jase

**motorbyclist** · 24th April 2011, 16:01

Originally Posted by Crock

Hi Guys, I am just getting into abit of bucketing and have fitted a 28mm OKO flat side to FXR 150. Is there an off the shelf throttle cable available... need the small nipple and different thread at carb end ???
Thanks.

Originally Posted by Crock

thanks but now all sorted thanks to a bit from Jase

Robinson Instruments are usually pretty good, too

**Ivan** · 24th April 2011, 20:20

anyone got any fork springs at all?

**Ivan** · 24th April 2011, 20:28

also a Cush drive setup for a Suzuki Rim

**Henk** · 24th April 2011, 23:15

Originally Posted by Ivan

also a Cush drive setup for a Suzuki Rim

I've got some Impulse / GSXR250 cushdrives taking up space in the garage, how many do you want?

**Ivan** · 24th April 2011, 23:40

Originally Posted by Henk

I've got some Impulse / GSXR250 cushdrives taking up space in the garage, how many do you want?

Just one would be good thanks haha I dont know what the rim is think its GSXR 250

**Henk** · 25th April 2011, 07:58

What frame is it going into? If it's an FXR you should be able to use the carrier that came with the bike.
The Impulse rear axle is the same size as an FXR but the GSXR is smaller.
If it's for a frame other than that measure up your rear axle and I'll see which of the two is closer and send that, they are pretty much identical other than the bearing sizes as far as I can tell.

**Ivan** · 25th April 2011, 12:13

its going into a chinese swing arm on a custom frame ill measure it up soon

**Henk** · 29th April 2011, 18:58

F5 project stage one is complete. I have a sort of running engine.
Now does anyone have an FXR rolling chassis they want to get rid of?

**Kendog** · 29th April 2011, 19:16

Originally Posted by Henk

F5 project stage one is complete. I have a sort of running engine.
Now does anyone have an FXR rolling chassis they want to get rid of?

Surely you don't want a heavy fxr frame for your 50?

**Henk** · 29th April 2011, 19:19

Engine is out of an XL100. Yes the frames are pretty heavy but I'm all geared up for crashing FXRs with spares and stuff, bike is going to be more for laughs and to get out there in F5 than to try and set the world on fire.
Plus I figure enough FXRs have been terminally blown up for there to be a few frames rotting in sheds.

**BOGAN02** · 30th April 2011, 14:48

Originally Posted by cotswold

I picked up an AX 100 the other day, I got it blind was just told it was a 2 stroke commuter, It is a a rusty heap but turns over, if any one wants it it's free to anyone who can be bothered to pick it up. Going to scrappy if not.
Cheers

id be pretty keen man. have you got a pic? and whats the deal with rego etc??