Activity Stream

Omihi was a very good ride. I dont know how James does it, but for a place where I have been at least 4 times before, the route was all different. I...

Not at all - I set a pretty low standard of evidence required for a certain claim. In case you missed it - to call Clarence Thomas corrupt, all I...

I had these guys make a fuel injection emitter ring for a project, good price and turnaround, exactly to the dimension I specified SSS Engineering...

My Thought exactly.

TDL seem to have wormed his way out of accepting any point made by anyone....reminds me of someone. I am willing to wait and see how all this...

Ahh, Wot a slacker.

Ask barikit for specific ringpin pos ...

My feeling is that many of the available MX pistons are designed to run in a case membrane engine and therefore they have a narrow skirt at the inlet...

Nice idea :yes: But as mentioned the cylinder is already at the limit of stability. Therefore I asked some pages back for the maximum inlet width....

Lieber Wolfgang ;) New idea! 😉 Why to stuck with 50,00 mm bore... For long therm its good to take parts as bearings and pistons that are...

never thought about this before until Wobbly somewhere mentioned this. But it’s long time ago… Now I’m looking for a 50mm piston with 12mm pin ...

Thanks Wolfgang for helping me with picture...never seen...but got it now:weird::brick::shit:

Hi Wolfgang I try to show it in the picture. In case length of skirt is shorter as the stroke you can see through the exhaust port in to the...

Finally found one today, which I think is from same source as the EMOT ones ...

Nice " Stoiga" racer from zündapp :drinknsin 😉 Short piston skirt is opening INLET port earlier...but not ex port But does this matter on a...

Wallace is on holiday. That's why I am looking for some other outfit.

I need new big end bearings for a TZ250 4DP. The stock Yamaha ones cost approx. 115,-€! Does anyone have an idea were to get silver caged bearings,...

Wallace hasn't been on here for a while. Is he still about? Have a great guy up here for doing things above my paygrade.

The project is to squeeze out a Zündapp Zuntrade cylinder. Thermosyphon cooled. Originally 92cc (with 47mm stroke). Now I have a 50mm crankshaft....

@Wos The Italkit piston from Langtuning has a skirt length of 46,5. Therefore it opens Exhaust at TDC in case 50mm stroke. Regarding the...

I got an itchy boots style wave from another ride couple weeks ago (full arm extend welcome to Liberia!) Gave me a chuckle as I imagined her voice...

Loving seeing the amount of diverse support for trump in this recent election. Harris won woman by only 10 points, compared to her predecessors...

Trump has announced that he intends to appoint FOX "News" anchor Pete Hegseth Secretary of Defence. It's not as bad as it sounds. Hegseth is MAGA...

I certainly can!

a bit over a week till this, have you got your calendar marked?

I think there is one thing we can all agree on: Melania is pretty damn tasty.

Mead mowers ? Now Brand engineering at Ashley. Looks like they could do it.

I had it done along time ago by some outfit in the middle of ChCh. For the life of me I cannot remember who did it; the word 'mead' come to mind...

Good point. I had not thought of that. I will look into it.